415-767-6905 | email@example.com
There was an error
If you believe this is incorrect, please contact us at firstname.lastname@example.org.
Wing kit with all necessary mounting parts. Available as lacquered or standard.
SKU #: REV-R01SB0160X
Manufacturer Part #: R01SB0160
Wing Chord: 225mm
Wing Width: 1650mm
Fitment: Lotus Elise/Exige S2
Material: 2x2 Twill pre-preg Carbon Fibre
Finish: Polished Carbon
Components: Wing, 2 x end plates,support tabs, 2 x Aluminium wing aupport legs & 2 x boot stiffners
Specially designed to fit the Lotus Elise/Exige S2, our lightweight Carbon Fibre curved rear wing kit has been engineered by aerodynamics writer and designer Simon McBeath to provide increased downforce and performance and add style to your Lotus. When run through CFD software in free stream air, the 225mm chord 1650mm wide rear wing gives approximately 179% more down force than the stock Exige wing (837N of down force vs. 300N stock, 100mph @ 12 deg AoA). Therefore it is essential for the downforce of the rear wing to be balanced by use of our Carbon Fibre front canards and Exige S2 Front Spoiler. The full aero package has been Wind Tunnel tested at MIRA and gives a similar aero balance to stock, with a 25% increase in drag (wide arch guise) but an amazing 200% more down force.
The wing is adjustably mounted to the clam on support legs (included) allowing you to fine tune the desired angle of attack.
We are able to provide a fitting service for this part, please contact us first before ordering.
|Manufacturer Part #
|Country of Manufacture
|4.41 lbs (2.0 kg)
|5.9" (15 cm)
|65.0" (165 cm)
|11.8" (30 cm)
|Yes (see note below)
Size and weight of different configurations may vary. For exact product weight and dimensions, please refer to the manufacturer's spec sheets or sizing sheets included in the description above or contact us.
CARB and EPA Emissions Statement: Based on the information provided to us by manufacturers and our own knowledge, we do the best we can to determine the CARB and emissions legality of the parts we sell. Please do your own research with the manufacturer to ensure that this part is legal for use in your state on the car you will be installing it on. If you believe that this part is incorrectly listed, please let us know at email@example.com. Parts which are not legal for use on emissions controlled vehicles in California and states which follow California CARB rules will require an affidavit to be signed by the customer certifying the part's use on a vehicle which is not emissions controlled.