Tillett W2 Race Car Seat Black GRP with Backframe

The W2 is a 25 mm wider handmade version of the W1. This is the black GRP version with a backframe.

Three types of our finish are available:

• Lightweight W1K handmade epoxy carbon Kevlar version
• Injected W1i black GRP
• W1i in Carbon/GRP which has an aesthetic layer of carbon fiber on the seating surface.

These seats can also be ordered with a seat covering made of the same material as Tillett’s kart racing seats which grips the body offering a small amount of vibration damping. A half covered example is ideal for open top cars. An alternative and popular covering option is a Dinamica® suede two-piece seat pad set listed as a configurable option.
A set of lap belt holes and a center strap hole are included with every seat. To mount the seat, the TK5 kit provides the hardware compatible with most cars.
The mounting points for the W2 are under the seat so that the TR1 seat sliders can be bolted directly to the underneath. Note that the runners must be spaced 1 cm from the underside of the seat to give clearance for the handle to operate.)
Mounting of the seat is also possible straight to the floor using a piece of 25 mm box section or runner system and Tillett's nylon spacers can be purchased to tip the seat at different angles.