415-767-6905 | help@torqued.io
There was an error
If you believe this is incorrect, please contact us at help@torqued.io.
$27.19
$24.47
SKU #: HOE-1558-467
Manufacturer Part #: 558-467
These two new MAP sensor adapters from Holley EFI allow you to quickly add a stainless steel MAP sensor to your existing installation. Holley part #558-466 adapts harnesses with a (MPFI) Weatherpack 3-pin connector to the 3-pin Delphi GT connector, commonly found on aftermarket stainless steel MAP sensors, such as the Holley 5-BAR MAP sensor, part #554-108. Holley part # 558-467 adapts harnesses with a Delphi M/P 150 3-pin connector, commonly found on LS engine harnesses, to the 3-pin Delphi GT connector
This product cannot be shipped to California.
Made by | Holley EFI |
---|---|
Manufacturer Part # | 558-467 |
GTIN | 090127081877 |
Weight | 0.25 lbs (0.1 kg) |
Height | 2" (5.1 cm) |
Width | 2" (5.1 cm) |
Length | 4" (10.2 cm) |
CARB compliant | No (see note below) |
Size and weight of different configurations may vary. For exact product weight and dimensions, please refer to the manufacturer's spec sheets or sizing sheets included in the description above or contact us.
CARB and EPA Emissions Statement: Based on the information provided to us by manufacturers and our own knowledge, we do the best we can to determine the CARB and emissions legality of the parts we sell. Please do your own research with the manufacturer to ensure that this part is legal for use in your state on the car you will be installing it on. If you believe that this part is incorrectly listed, please let us know at help@torqued.io. Parts which are not legal for use on emissions controlled vehicles in California and states which follow California CARB rules will require an affidavit to be signed by the customer certifying the part's use on a vehicle which is not emissions controlled.