415-767-6905 | firstname.lastname@example.org
There was an error
If you believe this is incorrect, please contact us at email@example.com.
The Planted Reinforcement Plate is used to reinforce a bolt or eye-bolt mounting point recommended when installing a harness in a non-factory location. Reinforcing a harness mount point is essential when the location has not been engineered by the auto manufacturer. Any time you mount a harness to sheet metal, you will need to put a reinforcement plate under it to keep it from ripping out of the floor. The Planted Reinforcement Plate uses a 7/16" - 20 nut welded to a 1/8th Inch thick piece of steel measuring 2 Inches x 3 Inches and then powder coated black.
The Planted Reinforcement Plate weighs about 1/3 lbs and is sold individually. Bolts or eye-bolts are not included.
|Manufacturer Part #
|Country of Manufacture
|0.30 lbs (0.1 kg)
|0.8" (2.0 cm)
|2" (5.1 cm)
|3" (7.6 cm)
|Yes (see note below)
Size and weight of different configurations may vary. For exact product weight and dimensions, please refer to the manufacturer's spec sheets or sizing sheets included in the description above or contact us.
CARB and EPA Emissions Statement: Based on the information provided to us by manufacturers and our own knowledge, we do the best we can to determine the CARB and emissions legality of the parts we sell. Please do your own research with the manufacturer to ensure that this part is legal for use in your state on the car you will be installing it on. If you believe that this part is incorrectly listed, please let us know at firstname.lastname@example.org. Parts which are not legal for use on emissions controlled vehicles in California and states which follow California CARB rules will require an affidavit to be signed by the customer certifying the part's use on a vehicle which is not emissions controlled.