Seat Accessories

• Lowest strap mount possible
• Mountable at 10°- 20° for OEM seats
• Fits all 991, 981, 718 chassis models

Harness mount reinforcement backing plate to prevent bolt ripping through floor.

Use to mount aftermarket seats to Planted adapter brackets consisting of 8x bolts, nuts & washers.

Spacer to raise seats from most major brands by 1/4". Sold as pair.

Use to mount aftermarket seats to seat side mounts. Contains 4x bolts, nuts & washers.

Universal sliders for use with most racing seats.

• Side cushions for thigh area to fit thinner drivers
• Fits Racetech 4009, 4119 and 4129 series seats

• Universal installation and application
• 7/16” UNF thread
• 65mm x 65mm x 3mm
• FIA compliant

Custom set of B1 pads with red accent stitching

• 2-piece seat pads set for B1 and B2 seats
• Dinamica® suede-like material

• 2-piece seat pads set for B4 seats
• Dinamica® suede-like material

Backing plate, filler and Dinamica fabric for a B5 seat headrest panel. Allows for local customization by embroider.

• 2-piece seat pads set for B5 seats
• Dinamica® suede-like material

Backing plate, filler and Dinamica fabric for a B6 or B6 Screamer seat headrest panel. Allows for local customization by embroider.

• 2-piece seat pads set for B6 XL, B6 XL Screamer & W2 models
• Dinamica® suede-like material

• 2-piece seat pads set for B6, B6 Screamer, B7 & W1i regular-wide models
• Dinamica® suede-like material

pads

Diamond stitched pattern customization available for all Tillett seat models with purchase of seat pads. Standard thread colors available.

Vertical piping and horizontal stitching for Tillett seat pads. Available for all Tillett seat models. Standard thread colors available.

Custom stitched headrest for Tillett seats. May require additional setup cost.

Black washer for use with M6 countersunk screws

Nylon mounting spacer. 40mm diameter. 10mm thick.

Nylon mounting spacer. 40mm diameter. 2mm thick.

Nylon mounting spacer. 40mm diameter. 4mm thick.

Nylon mounting spacer. 51mm diameter. 10mm thick.

Nylon mounting spacer. 51mm diameter. 2mm thick.

Nylon mounting spacer. 51mm diameter. 5mm thick.

Allows a slider to be mounted underneath the B6, W1 and W2 seats where the mounting holes are on the underside of the seat.

• Compatible with most Tillett seat brackets
• Direct bolt onto bottom-mount seats

• 90 mm wider version of TR1
• Use with outward-facing bracket installs or XL width seats

• Raises seat about 1" in the front
• 6061-T6 billett aluminum
• Use with Porsche LWB seats as found on GT3, GT3RS & GT4
• Available in black or natural finish